Okay so I tried this and all I get is the > prompt then E if I press enter
? brings up
h/? - print this help screen
r yyyyyyyy - read register/memory at address yyyyyyyy in hex
w yyyyyyyy zzzzzzzz - write zzzzzzzz to address yyyyyyyy in hex
j yyyyyyyy - jump to address yyyyyyyy in hex
x y - change the boot mode, where y is in hex
a - UART control passed to AP CPU ROM
c - UART control passed to CM3 CPU ROM
>
Do I need to set the jumpers in a certain order, RIght now J3 and J11 are set to 2-3 and J10 is set to 1-2.
Thank you,
