Home Forums Hardware discussions 3D printing of enclosure using STL file Reply To: 3D printing of enclosure using STL file

#829
nonesuch
Participant

Agreed. I tried printing the bottom with support material, but this causes a single layer of support which is too thin to stick together. I can’t peel off this support because tiny pieces keep breaking off.

Images

I could try printing the model upside down, so that the support sticks together well enough that I can just flex it off. This usually works. But it would be much smarter just to design the case so it lays flat.

Signup to our newsletter

Technical specification tables can not be displayed on mobile. Please view on desktop