[libolt4]

It did not come with a microSD card. I had to use one I already owned by opening the case and plugging it into the board.

[libolt4]

Is there anything else I can try? What doesn’t make sense to me is that I follow the UART recovery instructions, everything completes successfully and when I go back to the console it just as the > prompt.

Also I have tried the different images for 1 gig and 2 gig boards as I am not sure what i have. I bought mine from Amazon: Globalscale Technologies, Inc. V7 64 Bit Single Board Computer Network Switch, ESPRESSOBIN+ board with Enclosure

Is there a way I can tell by looking at the board?

[libolt4]

I just wanted to follow up and see if anyone had other ideas. I would really like to get this board working.

Thank you,

[libolt4]

Okay so I tried this and all I get is the > prompt then E if I press enter

? brings up

h/? - print this help screen 
r yyyyyyyy - read register/memory at address yyyyyyyy in hex 
w yyyyyyyy zzzzzzzz - write zzzzzzzz to address yyyyyyyy in hex 
j yyyyyyyy - jump to address yyyyyyyy in hex 
x y - change the boot mode, where y is in hex 
a - UART control passed to AP CPU ROM 
c - UART control passed to CM3 CPU ROM 
>

Do I need to set the jumpers in a certain order, RIght now J3 and J11 are set to 2-3 and J10 is set to 1-2.

Thank you,

[libolt4]

Nevermind. I was able to download Image on my phone via my data connection and transfer it to my computer from there.

[libolt4]

So I have run into an issue downloading the Image file. It failed multiple times from Firefox so I tried with wget. Wget gets to 86% and fails. I specified -c to resume and it keeps attempting to resume but says “Data connection: connection reset by peer; Data transfer aborted.”

[libolt4]

Kevin,

Thank you for the response. I will give that a try and provide an updte when I have a free moment.

Thank you again.

[Author]

Posts