eth1: 2,5Gbps (I suppose it’s the SFP one)
eth2: 1Gbps (WAN POE)
[ 8.997956] mvpp2 f2000000.ethernet eth0: configuring for inband/10gbase-r link mode
[ 9.012377] mvpp2 f2000000.ethernet eth1: configuring for fixed/2500base-x link mode
[ 9.020489] mvpp2 f2000000.ethernet eth1: Link is Up – 2.5Gbps/Full – flow control off
[ 9.054435] mvpp2 f2000000.ethernet eth2: PHY [f212a200.mdio-mii:01] driver [Marvell 88E1510] (irq=POLL)
[ 9.064028] mvpp2 f2000000.ethernet eth2: configuring for phy/rgmii-id link mode
[ 9.072596] mvpp2 f2000000.ethernet eth1: Link is Down
[ 9.079022] mvpp2 f2000000.ethernet eth1: configuring for fixed/2500base-x link mode
[ 9.086889] mvpp2 f2000000.ethernet eth1: Link is Up – 2.5Gbps/Full – flow control off
The 2,5 Gbps is not a real surprise as I already have a machiatobin with the same hardware (mvpp) and there is also a 1Gbps/2,5Gbps port that I use for my fiber access.
Just installed arch linux and with kernel 5.16, I have to choose between my 1G SFP or the WAN POE, both don’t works.
So my setup now is 10Gbps to the switch and the board is powered with POE and admin interface is on the WAN.
I first do a usb start and then:
Here is my bootcmd
setenv bootcmd ext4load usb 0:2 $kernel_addr_r $image_name; ext4load usb 0:2 $fdt_addr_r $fdt_name; setenv bootargs $console root=/dev/sda2 rw rootwait net.ifnames=0 usbcore.autosuspend=-1 biosdevname=0; booti $kernel_addr_r – $fdt_addr_r